M57N and M57N2 wideblock to MT82 TDCI/TD4 Gearbox Adapter Kit
This kit allows you to bolt a BMW M57 306d2 wideblock onwards engine to the Land Rover/Ford TDCI/TD4 MT82 gearbox.
Allows use of original Clutch release bearing/slave cylinder, original GENUINE BMW clutch cover and dual mass flywheel. A non self adjusting cover is recommended
Engine runs at correct angle with flat sump.
Kit includes:
Adapter plate and fasteners
Spigot Bearing
Clutch Plate (cover and DMF not included) Should be upgraded as required if engine mapped above standard.
Starter motor cover block (not pictured)
Recommended Clutch and Flywheel to use. Use these parts only.
Valeo Slave/Bearing: 810206
Sachs Clutch Cover: 883082001243
Sachs Flywheel: 2294001391
FITTING VIDEO:
Bolt adapter to engine with fasteners supplied.
Fit new spigot Bearing flush with end of crank spigot
Replace standard BMW clutch plate with plate supplied in kit. Retain original GENUINE BMW clutch cover
Cut Bell housing to match adapter for starter motor clearance.
Bolt Bell housing to adapter with start cover block.
*NOTE- IF USING AFTERMARKET CLUTCH COVERS/KITS THAT ARE NOT PART OF THIS KIT, ENSURE THAT THEY DIMENSIONALLY MATCH THE GENUINE BMW CLUTCH
Registered with the Intellectual Property Office
See below our ‘What’s in the Box’ video for this kit:
Reviews
There are no reviews yet.