M57N and M57N2 wideblock to Ford Transit MT82 2.2 Gearbox Adapter Kit
This kit allows you to bolt a BMW M57N 306d2 onward wideblock engine to the Ford TDCI 2.2 MT82 gearbox.
Allows use of original Clutch release bearing/slave cylinder, original fitment BMW clutch cover and dual mass flywheel. A non self adjusting cover is recommended
Engine runs at correct angle with flat sump.
Kit includes:
Adapter plate and fasteners
Spigot Bearing
Clutch Plate (cover and DMF not included). Should be upgraded as required if mapping above standard power.
Starter motor cover block (not pictured)
Release Bearing Shim (not pictured)
Recommended Clutch and Flywheel to use. Use these parts only.
Valeo Slave/Bearing: 810206
Sachs Clutch Cover: 883082001243
Sachs Flywheel: 2294001391
FITTING VIDEO:
Bolt adapter to engine with fasteners supplied.
Fit new spigot Bearing flush with end of crank spigot
Replace standard BMW clutch plate with plate supplied in kit
Cut Bell housing to match adapter for starter motor clearance.
Fit bearing shim over end of release bearing.
Bolt Bell housing to adapter with start cover block.
Registered with the Intellectual Property Office
See below our ‘What’s In The Box’ video for this kit:
Reviews
There are no reviews yet.