M57 to Ford Ranger MT82 2.2 Gearbox Adapter Kit
This kit allows you to bolt a BMW M57 306d1 engine to the Ford TDCI 2.2 MT82 gearbox.
Allows use of original Clutch release bearing/slave cylinder, original BMW clutch cover and dual mass flywheel. A non self adjusting cover is recommended
Engine runs at correct angle with flat sump.
Kit includes:
Adapter plate and fasteners
Spigot Bearing
Clutch Plate (cover and DMF not included) To suit 184bhp. Should be upgraded as required.
Starter motor cover block (not pictured)
Recommended Clutch and Flywheel to use. Use these parts only.
Valeo Slave/Bearing: 810206
Sachs Clutch Cover: 883082001243
Sachs Flywheel: 2294001391
FITTING VIDEO:
Bolt adapter to engine with fasteners supplied.
Fit new spigot Bearing flush with end of crank spigot
Replace standard BMW clutch plate with plate supplied in kit
Cut Bell housing to match adapter for starter motor clearance.
Bolt Bell housing to adapter with start cover block.
Registered with the Intellectual Property Office
See below our ‘What’s in the Box’ video for this kit:
Conner Storey (verified owner) –
Used 2 these adapters with 5 and 6 speed tranits well made fast service will deffo be buying again